Technical services

Technical Guidance & Training.

We don’t just sell equipment — we make sure you can run it, maintain it, and fix it.

Services

Five ways we stay involved after the specification

Most of the value in an industrial project is created — or lost — after the equipment arrives. These services cover that window.

Service 01 · Free of charge

Pre-Sales Technical Consultation

Initial technical discussion and solution confirmation — free of charge.

  • Free
  • No obligation
  • Solution confirmation

Service 02

Production Guidance

Remote or on-site guidance for local fabrication and manufacturing. We review your production quality and provide corrective recommendations.

Service 03

Installation & Commissioning Supervision

On-site supervision for equipment installation and commissioning. We ensure the equipment is installed correctly and runs to specification.

Service 04

After-Sales Diagnostics & Repair Solutions

Troubleshooting for equipment failures and performance issues. Diagnosis and repair solutions — remotely or on-site.

Service 05

Operation & Maintenance Training

Structured training programs for operators and maintenance teams. We cover daily operation, preventive maintenance, and common fault handling.

  • Daily operation
  • Preventive maintenance
  • Common fault handling

Not sure which you need?

Describe the symptom or the stage your project is at. We will tell you whether it needs remote input, a site visit, or nothing at all.

Pricing note. Pre-sales consultation is free. On-site services are charged per man-day (travel expenses separate). Training programs quoted per session.

Standards

Designed to codes we can name

When we review your production, supervise an installation or diagnose a fault, there is a document behind the advice. These are the standards our equipment design and acceptance work is anchored to.

Standards referenced in our design, manufacturing and acceptance work

StandardScopeWhere it applies
GB 3811Crane design codeStructural and mechanism design of cranes and mast cranes
SD 160Technical conditions for cranes used in water-conservancy and power constructionManufacturing requirements for power-sector lifting equipment
GB 6067Safety rules for lifting appliancesInstallation checks and load testing before the machine is released for use
GB 1102Steel wire ropesHoist and luffing rope specification

Acceptance is part of the service. A machine is not handed over until it has been checked and load-tested to the applicable code. If your national regulations require a different standard, tell us at the assessment stage — it changes the design inputs, not just the paperwork.

Capability transfer

The point is that your team no longer needs us

Our clients are port authorities, mining companies, cement plants and grain terminals. They do not want a permanent dependency on a foreign supplier — they want a maintenance team that can keep the line running.

So the training is structured for handover: your people learn the daily checks, the early warning signs, and how to handle the faults that actually stop production.

  • Training delivered on your equipment, not on slides alone
  • Written procedures your team can keep and reuse
  • Diagnostics support available after the programme ends
Instructor running an on-site maintenance training session for operators

Structured programmes for operators and maintenance teams.

Questions

Before you get in touch

Is the pre-sales technical consultation really free?

Yes. The initial technical discussion and solution confirmation are free of charge, with no obligation to proceed.

How are on-site services charged?

On-site services are charged per man-day, with travel expenses billed separately. Training programmes are quoted per session, so you know the cost of a programme before it starts.

Can you diagnose a fault remotely?

In many cases, yes. We provide remote troubleshooting for equipment failures and performance issues, and follow up on site when the problem cannot be resolved remotely. Sending photographs, operating data and a short description of the symptom is usually enough to get started.

Do you train local fabricators as well as operators?

Yes. Production guidance is a separate service aimed at local fabrication and manufacturing: we review your production quality and provide corrective recommendations, remotely or on site.

Need technical support?

Contact us to discuss your requirements. Pre-sales consultation is free, and we reply within 24 hours.

Chat on WhatsApp